HT Spall-FX is a rapid set, high strength ultra low viscosity Polyurea repair material. This two part, 1:1 system is 98% solids and designed for rebuilding and repairing broken control joints and spalled concrete surfaces very quickly. HT Spall-FX is intended for use in damaged control joints or warehouse spalls where there is no movement and damage is from steel wheels or small hard urethane wheels.

Data Sheet:

Rebuilding control joints
Shallow spalls on bridge decks
Traffic area spalls & crack repairs
Grade matching
Floor repair
Freezer/Cold Storage Thresholds
Stops additional damage
Fill & repair spall before coating
Used to “knit” cracked slabs


Demonstration Videos:

Meets USDA and FDA Requirements
Cures from  -20° F to 130° F.
“Drive-Over” in 10 to 15 minutes
Produces High Strength Quickly
Self-leveling
Self Priming
Fast initial set; rapid gain to ultimate strengths.
 

Viscosity (Mixed)...............................................25 cps
Hardness, durometer (ASTM D2240).......67 to 72D
Tensile Strength, PSI (ASTM D412)...................4600
Tear Strength (ASTM D624)......................-lb/mil 489
Elongation % (ASTM D412)..........................6% to 8%
Compressive Strength (neat)......................3900 psi
(ASTM C109)       (with sand).........................4800 psi
Bond Strength (ASTM 882-99)......................3450 psi

22 oz. & 56 oz. Cartridges
1 Gallon Kit (with proportioning chambers)
2 Gallon,
7 Gallon
10 Gallon Kits